Parts & Assembly Instructions for Magnum Target 24" 2x4 Steel Shooting Target Stand - 2x4STD-1CB-2LEG-NP

Magnum Target 24" 2x4 Steel Shooting Target Stand

Click HERE to view the listing

Included Parts:

(1) 24" Stand Crossbeam - Unpainted

(2) 24" Stand Legs - Unpainted

(4) 1/4" Lag Screws

(4) 3/8" Carriage Bolts

(4) 3/8" Hex Nuts

Assembly Instructions

1. The Stand Crossbeam comes pre-welded with a center mounting area for wooden 2x4 and mounting brackets on either side for mounting the 24” Stand Legs.  
2. The Legs will be attached using (4) included 3/8" bolts and nuts. They are designed with rounded 20 degree cut-outs on the top. Center crossbeam should be mounted straight up and down perpendicular to the ground.
3. The wooden 2x4 should be mounted straight up and down using (4) included 1/4" lag screws. Two on either side. A power drill or impact driver is recommended. 1/4" through bolts and nuts are an alternative but not included. Give clearance between the bottom of the wooden 2x4 and ground surface. 
4. Your stand is now ready for any 2x4 topper hook and target.